Jump to content
Geochemist's Workbench Support Forum

Error: Didn't wake up, abandoning path


MSZ

Recommended Posts

Hi Masoud,

 

Sorry I didn't notice your earlier post. All reactions in the GWB are written as destruction reactions (i.e., Quartz dissolves to form SiO2(aq)). You can set a single kinetic rate law for mineral dissolution or precipitation because the degree of saturation is what controls whether the rate is positive or negative. A general rate law might have the form r = k * A * (1 - Q/K), where k is the rate constant, A is the mineral's surface area (product of mass and specific surface area), Q is the ion activity product, and K is the equilibrium constant. If a mineral is undersaturated then 1 - Q/K is positive, indicating dissolution. On the other hand, if a mineral is supersaturated, however, 1 - Q/K is negative indicating precipitation.

 

You should not set a negative value for the rate constant. If you'd like to set a different rate law depending on whether a mineral is over or undersaturated you can specify a custom rate law. You should still follow the convention of a postive rate indicating dissolution and a negative rate indicating precipitation.

 

Hope that helps get you started. If your model is taking a long time, it might be that your reaction is too fast and is forcing the program to take very small time steps. If that's the case, a kinetic rate law may not be necessary. Another option might be to change some of the parameters in the Config -> Stepping dialog like delxi or delQ. Try taking a look in the GWB Reference Manual for some of these commands.

 

Regards,

 

Brian Farrell

Aqueous Solutions LLC

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...