Jump to content
Geochemist's Workbench Support Forum
Polly Tsai

Regarding Se(c) solubility calculation in the groundwater using React module

Recommended Posts

Dear Brian,

Thanks for your previous response. Based on your instruction, I repeated to run the UO2 solubility calculation by addiding uraninite to the Basis pane. The result was almost the same as that of technical report (a little bit difference of GW conditions between two sites), please refer to the attached script file (UO2 solubility_32C.rea). However, when I performed Se solubility calculation using the above same method (1.0 fee mol/l) or even I input the other arbitrary values (0.001, 0.01, 0.01...) for Se , the result showed "Newton-Raphson did not converge after 999 iterations,....". What is wrong in this case?

Thanks for your further response.

 

Polly

 

Se solubility_32C.rea

UO2 solubility_32C.rea

Share this post


Link to post
Share on other sites

Hi Polly,

I’m glad to hear that your uraninite solubility calculation worked out well. 

You might try charge balancing on a different ion, or disabling charge balancing entirely, since this is a simple solubility diagram calculation. 

Regards,

Brian Farrell
Aqueous Solutions
 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×