Isaac Mantelli

Rethought the design of this model. Still looking at diffusion through a fracture, but now I've edited the porosities of the middle row of nodes to be 1 to act as the fracture and removed the well sites for simplicity. I've also replaced kinetic minerals with simple minerals. However, now the model fails to converge at the same reaction progress, about 0.145. I have tried changing nearly each variable one at a time, but I still cannot find what is causing the model to stop at that point. fracture size sensitivity analysis simple minerals.x2t

I am building a simulation based on experimental work involving fluid diffusion through a fracture and into a rock matrix. This model assumes half of the fracture, where the well (injection) site is the fracture aperture. Fluid chemistry is from analyzed samples. The rock is an ultra-tight shale, hence the very large SSA. The simulation fails after a very small reaction progress (Xi < 10^-6) with max residuals around 10^-11. I have removed all but essential ions and minerals. I would appreciate any insight! fracture size sensitivity analysis.x2t

In React, I have built a fluid in the basis and rock made from kinetic minerals in the reactants pane. From what I can tell, my options in React are to slowly titrate the rock into the fluid, or do a flow-through or flush (neither of which I want). Rather, what I want is to throw my entire rock in the fluid and see what happens after 30 days. How do I do this?

This worked. Thank you for your help.

Attached is the error message with activation code crossed out. The status says activated. The request in the error message refers to pressing the "Deactivate" button.

I am getting an unknown error message when I try to deactivate my license on one computer to move it to a new computer. This does not seem to be related to the number of times I have done this process (so far only once). Any chance I can get this reset?