mixing fluids

[Rosario]

I am trying to mix seawater with a well water in react, how do you go about it?

[Tom Meuzelaar]

I am trying to mix seawater with a well water in react, how do you go about it?

 

Hi Rosario:

 

The key is to use the Pickup command. The following general set of steps works for all fluid mixing models:

 

• Load water 1 into the React Basis panel
  
• Speciate water 1
  
• After React converges, "pick up" the speciated fluid via the Run - Pickup - Reactants option (you can pick up the entire speciated system, or the fluid or mineral components only). This will load water 1 component masses into the Reactants pane after speciation.
  
• Load water 2 into the Basis pane
  
• To set a mixing fraction, use the reactants times option in the Reactants pane
  

 

The above instructions are for titrating water 1 into water 2. If you want to run the reverse mixing model, simply reverse the order.

 

I hope that helps,

 

Tom Meuzelaar

RockWare, Inc.

[Rosario]

Hi Rosario:

 

The key is to use the Pickup command. The following general set of steps works for all fluid mixing models:

 

• Load water 1 into the React Basis panel
  
• Speciate water 1
  
• After React converges, "pick up" the speciated fluid via the Run - Pickup - Reactants option (you can pick up the entire speciated system, or the fluid or mineral components only). This will load water 1 component masses into the Reactants pane after speciation.
  
• Load water 2 into the Basis pane
  
• To set a mixing fraction, use the reactants times option in the Reactants pane
  

 

The above instructions are for titrating water 1 into water 2. If you want to run the reverse mixing model, simply reverse the order.

 

I hope that helps,

 

Tom Meuzelaar

RockWare, Inc.

[Rosario]

Tom

Thank you